5 d

Re: No spark on any cylin?

Temporarily remove the black/yellow wire (kill circuit) ?

Plastic covered coils can develop cracks in the casing or cracks can develop in wire coverings which lets the current leak or arc out to the engine block. The model # 140843c and serial # j0002615. Check spark condition using a tester gap, set tester gap at 5/16. I tested the compression and its good It turns over very good but no spark. I have changed out the stator, timer base, and power pack with all new CDI components. neil flynn wife Removed the yellow/back wire from the power pack (still no spark). Jun 14, 2007 · Re: johnson gt200 200 hp wont start no spark Run it long as you like at idle speed [** with the hose hooked up **] , but don't rev it any higher than needed to keep it going. I pulled the plugs and grounded them and didn't get any spark at all. Thread starter sid0120; Start date Oct 20, 2012; S Oct 20, 2012 #1 I have a FD-20C 20 HP Johnson Can you tell me the year? Also, there is a spot next to the rich/lean knob that says. demiley cyrus in leggings Number 3 (bottom cyl) no spark bad coil but 1 bad cyl should not kill the starting. No spark 1968 Johnson 40Hp. I don't have much experience trouble shooting electrical problems and I am at witts end, I am steering towards the ignition box probably because I don't know how to check it, I don't think both coils would go at once and there are no points or condencer's any ideas would be apreciated, Thanks, Jeff. Being new to outboards, I didnt see exactly how to do this. Then I measured voltage coming into the coil (orange-green wire & ground, orange-blue wire & ground) and it only showed 17 volts respectfully when cranking. Checked to make sure the stop switch was working witch it was. how to get mods on btd6 Today we look at a Johnson outboard with no spark can we fix it 😀#fixit #diy https://youtu. ….

Post Opinion